Industrial Oxygen
Industrial oxygen for oxy-fuel cutting, brazing, heating and fabrication, with oxygen-rated equipment and fuel-gas pairing kept front of mind.
Where industrial oxygen fits.
Best for
- Oxy-fuel cutting and maintenance
- Brazing, heating and fabrication
- Laser cutting on thicker mild steel where oxygen assist is already specified
- Selected process jobs where oxygen already specified
Check before ordering
- Confirm the current fuel gas, regulator and connection details
- Keep oxygen equipment oil-free, grease-free and oxygen-rated only.
- If this is shielding gas rather than oxy-fuel work, move to the welding-gas path instead.
Industrial oxygen is the cutting and heating lane.
This is the practical starting point for oxy-fuel work, maintenance cutting, brazing, heating and thicker mild-steel laser cutting where oxygen is already part of the setup.
Oxygen itself is not flammable, but it accelerates combustion hard.
That is why oxygen equipment must stay oil-free, grease-free and matched to oxygen service only.
Pair it with the right fuel gas.
If you are replacing an existing oxy-fuel setup, send the current oxygen and fuel-gas details and we will match the supply cleanly.
Industrial oxygen is used with fuel gases for oxy-fuel cutting, brazing and heating, plus thicker mild-steel laser cutting and selected process work where oxygen is already specified. It is not flammable, but it strongly supports combustion, so oxygen equipment must be kept clean and oil-free.
Cylinder sizes
Published sizes. Not every application needs a G – we’ll size it to your actual draw rate.
| Size | Contents (m³) | Pressure @ 15°C | Water Capacity (L) | Colour | Connection |
|---|---|---|---|---|---|
| C | 0.6 | 19000 | 3 | Peacock Blue | Type 10 |
| D | 1.9 | 19000 | 10 | Peacock Blue | Type 10 |
| E | 4.5 | 19000 | 23-25 | Peacock Blue | Type 10 |
| G | 9.5 | 19000 | 50 | Peacock Blue | Type 10 |
| 12 Pack | 118 | 19000 | 600 | Peacock Blue | Type 10 |
Cylinder contents pressure is referenced at 15°C. Actual pressure can vary with ambient temperature.
Hazards
- Oxygen is an oxidising gas.
- Keep oxygen equipment free from oil, grease and hydrocarbon contamination.
Industrial Oxygen SDS
What matters on site
Keep regulators, hoses, valves and fittings free from oil, grease and hydrocarbon contamination.
Use oxygen-rated equipment only and keep the setup matched to the current installation.
Secure cylinders upright and store them away from heat, ignition and physical damage.
Replacing an existing oxy-fuel setup? Send the oxygen and fuel-gas details and we will match it cleanly.
Frequently Asked Questions About Industrial Oxygen
Most oxygen jobs sit alongside a fuel gas or a separate welding-gas path.
These are the next practical gases to check if you are replacing an existing setup.
